Envirograph Stoveseal 1250°C - 310ML - BLACK

Product Number: 115 Stoveseal

 

Description:

A ready-mixed, ready-to-use, finely-ground putty substance which remains flexible until cured. Ideal for patching and repairs to fire-bricks, fireplaces, solid fuel ovens, ranges, boilers and around register plates.

 

Uses:

For bonding and sealing between a wide range of materials such as metal, glass, ceramic, concrete, stone, clay and silicate (glass) fibre. Provides a high temperature, rigid seal around pipework and flues in fireplaces, boilers, solid fuel burners and central heating systems. General fire protection wherever a rigid seal is required. Limitations: Stoveseal will not bond plastics materials, particularly where flexing may occur. Not to be used in permanent contact with water.

 

Technical Details:

Density: 1.75-1.85g/cm3

Flash Point: does not support combustion

pH: 13 Application

Temperature Range: 5 oC to 40oC

Service Temperature Range: -20oC to 1250oC (starts to soften at 1200oC; melts at 1300oC)

Slump Resistance: Excellent. Soft highly thixotropic paste. Initial Drying: Skins within 5 minutes (20oC and 65% RH)

Through drying: Approx. 5mm/day (20oC and 65% RH)

Oxidation resistance: Excellent

Acid Resistance: Excellent (except for hydrofluoric acid)

Shelf Life: 12 months in unopened containers stored in cool, dry conditions.( 5oC to 30oC) Colour: natural (buff) other colours available on request.

Coverage: 45m for a 3mm diameter bead for a 310ml cartridge

310ml tube

 

Product Number: 115 Stoveseal

 

Description:

A ready-mixed, ready-to-use, finely-ground putty substance which remains flexible until cured. Ideal for patching and repairs to fire-bricks, fireplaces, solid fuel ovens, ranges, boilers and around register plates.

 

Application:

For maximum adhesion, remove all dirt, dust and rust and ensure that the area of application is clean. Cut off the cartridge seal and screw nozzle onto cartridge. Cut the nozzle to the required bead size. Apply the adhesive from the cartridge, forcing it onto the area to be sealed, then immediately tool it down to ensure good adhesion. Complete tooling within 5-10 minutes. When bonding materials, apply a bead of adhesive to one surface and immediately combine the two parts, applying pressure to ensure good surface contact. Application equipment should be cleaned with warm water after use. It is necessary to fully dry the product before subjecting to temperatures above 100°C to prevent gassing and likely failure or the seal/bond. Allow to air dry for 36-48 hours, after which gentle heat can be applied.

The dried product can be removed with boiling water.

 

Storage:

Store in cool dry conditions (5°C to 30°C)